Publicidad
Idiomas disponibles
Idiomas disponibles
•
When sawing metal, use a special blade.
•
Saw with a low but even speed.
•
When cutting profiles, start cutting at the thin side.
•
When cutting U-shaped profiles, start cutting at the closed side.
CLEANING
Cleaning overview. Regularly and according to the operating conditions
•
Clean the ventilation slots, using a vacuum or brush to clean the motor and remove any
dust.
•
Clean the device. Wipe the unit with a damp
•
cloth.
TROUBLESHOOTING
What to do when something doesn't work...
DANGER! Risk of injury! Unprofessional repairs may mean that your unit will no
longer operate safely. This endangers you and your environment.
Malfunctions are often caused by minor faults. You can easily remedy most of these yourself.
Please consult the following table before contacting the vendor. You will save yourself a lot of
trouble and possibly money too.
Error/Fault
The device does not work.
Sawing performance is not
good enough.
Saw blade distorted
If you cannot fix the fault yourself, contact your nearest vendor. Please be aware that any
improper repairs will also invalidate the warranty and additional costs may be incurred.
DISPOSAL
Disposal of the appliance
Appliances which are labelled with the adjacent symbol must not be disposed of in
household waste. You must dispose of any such old electrical and electronic
equipment separately.
• Please check with your local authority about the possibilities for correct disposal.
Through separate disposal you send old equipment for recycling or for other forms of re-
use. You will thus help to prevent damaging material from getting into the environment in
some cases.
Cause
Is the device faulty?
Is the saw blade unsuitable
for the material?
Is the saw blade worn?
Too much load?
30
Remedy
Contact your local vendor.
Fit an appropriate saw blade.
► Fitting the saw blade
Reduce the pressure on the
sawblade.
Publicidad
