Weed Eater GHT 195 Manual De Instrucciones página 5

OPERATING POSITION
3. Slowly press the primer bulb 6 times.
4. Move the choke lever to the FULL CHOKE
position.
Primer Bulb
Choke
Lever
STOPPING YOUR ENGINE
• To stop the engine, move the ON/OFF
switch to the OFF position.
STARTING YOUR ENGINE
• Fuel engine. Move at _east 10 feet (3 me-
ters) away from the fuefing site.
• Hold the unit on the ground in the starting
position as shown. Support unit so the
blade is off of the ground and away from
trees, bushes, onlookers, etc.
/ !- i
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
Throttle Lock
._ Throttle t
Throttle _-f___ -_"-_
Trigger I_ /'_--_'T_-_ - __'_ "_-- _ -_
1. Move the ON/OFF switeh to the ON posi-
tion.
2. Engage the throttle lock as follows:
• press the throttle lock-out;
• squeeze and hold throttle trigger;
• press and hold throttle lock, then
• release the throttle trigger
NOTE: Keep the throttle lock engaged until
the engine starts.
ON OFF
Switch
5. Pull starter rope handle sharply until en-
gine sounds as if it is trying to run, but do
not pull rope more than 6 times.
6. Move the choke lever to the HALF
CHOKE position.
7. Pull starter rope sharply until the engine
runs, but no more than 6 pulls.
NOTE: If the engine doesn't start after 6 pulis
(at the HALF CHOKE position), check to
make sure the ON/OFF switch is in the ON
position. Move the choke lever to the FULL
CHOKE position and press the primer bulb 6
times; pull the starter rope 2 more times.
Move the choke lever to the HALF CHOKE
position and pull the starter rope until the en-
gine runs, but no more than 6 more pulls. If
the engine still doesn't start, it is probably
flooded. Proceed to STARTING A FLOODED
ENGINE.
8. Once the engine starts, allow the engine to
run 10 seconds, then move the choke iever
to the OFF CHOKE position. Allow the unit to
run for 30 more seconds at the OFF CHOKE
position before squeezing and releasing the
throttle trigger to release the throttle lock.
NOTE: If engine dies with the choke lever in
the OFF CHOKE position, move the choke le-
ver to the HALF CHOKE position and pull the
rope until the engine runs, but no more than 6
pulis.
STARTING A WARM ENGINE
1. Move the ON/OFF switch to the ON posi-
tion.
2. Slowly press the primer bulb 6 times.
3. Move the choke lever to the HALF
CHOKE position.
4. Engage the throttle lock as directed in
STARTING A COLD ENGINE.
NOTE: Keep the throttte lock engaged until
the engine starts.
5. Pull starter rope sharply until engine runs,
but no more than 5 pulls.
6. Altow the engine to run t0 seconds, then
move the choke lever to the OFF CHOKE
position.
7. Release the throttte _ock by squeezing and
releasing the trigger.
NOTE: If engine has not started, pull starter
rope 5 more pulls. If engine still does not run, it
is probably flooded. Proceed to STARTING A
FLOODED ENGINE.
-5-