Deleting All Learned Keys In A Specific Mode; Programming Channel Control Lock; Unlocking Channel Control - Universal Electronics ATLAS DVR/PVR 5-DEVICE Guia Del Usuario

Deleting All Learned Keys in a Specific Mode

NOTE: If more than 15 seconds pass between key
presses, the remote exits programming.
1. Press and hold SETUP until the last-selected
mode key blinks twice, then press 9 7 5.
2. Press a mode key twice (i.e., AUX, DVD, AUD,
TV, or CBL) to clear all the learned keys for
that mode. The LED blinks twice.
3. Repeat step 2 for another mode or press and
hold SETUP to exit programming.

PROGRAMMING CHANNEL CONTROL LOCK

By default, the remote control's channel-control
capabilities are locked to the cable converter. The
*
affected keys are 1 through 0, CH+, CH-, ENTER, and
LAST. This will guarantee that you do not inadvertently
change a channel on your TV or VCR. However, you can
de-activate this feature to allow full access to these keys
in the TV and VCR modes.
*
NOTE: This feature does not affect the AUD mode.

Unlocking Channel Control

1. On the remote control, press CBL once; it will
blink once. Press and hold SETUP until the
CBL key blinks twice.
2. Enter 9 7 3. The CBL key will blink twice.
3. Press CH- once. The CBL key will blink four
times.
Now the remote control will provide TV and VCR
channel-control capabilities while in the TV or VCR
mode.
www.urcsupport.com
15