Clearing The Master Power Key; Re-Assigning Device Keys - Universal Electronics ATLAS DVR/PVR 5-DEVICE Guia Del Usuario

Clearing the Master Power Key

1. On the remote control, press and hold SETUP
until the last-selected device key blinks twice.
2. Enter 9 9 5. The last-selected device key
blinks twice.
3. Press and release PWR.
4. Press and hold SETUP until the CBL key blinks
twice.

RE-ASSIGNING DEVICE KEYS

The Atlas DVR/PVR 5-Device Universal Remote Control
with Learning can be set up to control a second device of
an already-assigned type. For example, to have the unit
control a TV, a Cable Converter, and two DVD players,
re-assign the unused AUX key to operate the second DVD
Player as follows:
NOTE: AUX is preset at the factory to control an RCA
VCR. Performing the steps below will over-
write those settings.
1. On the remote control, press AUX once; it will
blink once. Then press and hold SETUP until
the AUX key blinks twice.
2. Enter 9 9 2. The AUX key will blink twice.
3. Press DVD once, then press AUX once. The AUX
key will blink twice.
The AUX key is now ready to be programmed for your
second DVD player. See "Programming Device Control"
on page 8. To re-assign other device keys, repeat these
and substitute the key sequence using the following
chart:
www.urcsupport.com
21