Publicidad
Idiomas disponibles
Idiomas disponibles
2. Position the Nemo GRABO® firmly against the surface of the object you want to lift.
3. Press the green motor power button Ⓒ . A seal is created within seconds.
4. Lift and move the object.
! When lifting smooth materials (such as glass, smooth tiles, and marble), you can press the
green motor power button Ⓒ again to switch off the motor once the seal is created. When
lifting slightly porous materials (such as wood, timber, drywall, concrete, or cardboard), make
sure the Nemo GRABO® motor remains on while lifting.
! When lifting materials with dusty, dirty, or moist surfaces, remove the dust and dirt as much as
possible and keep the motor on at all times.
TO END OPERATING THE NEMO GRABO®
1. When you are done and the object is in a secure and stable position, press the red vacuum
release button Ⓑ to break the seal and release the object.
CHARGING AND CHANGING THE BATTERY ❼
Charge the battery when the capacity is low or the battery is empty.
CAUTION: Use the Nemo GRABO® only with the original Li-ion 2600 mAh battery (article
number TB05000) and the original multi-socket battery charge (article number SP94112).
1. Slide the battery latch to unlock the battery Ⓐ .
2. Remove the battery.
3. Connect the battery with the multi-socket battery charger to a wall socket.
4. When the battery is fully charged, the battery bar indicator Ⓔ turns green.
5. Disconnect the multi-socket battery charger from the wall socket and battery.
6. Put the battery in the battery compartment.
7. Press and slide the battery latch to lock the battery.
! During the process of charging, the charger can become warm: this is normal.
! Only use the charger in a dry environment. The charger is not waterproof.
! Ensure that the power supply voltage corresponds to the data on the nameplate of the battery
charger.
! Keep away from flammable objects while charging.
NEMO GRABO® | Operator's manual
19
Publicidad
