Publicidad
Idiomas disponibles
Idiomas disponibles
Risk of unsafe
operation. Overfilling with oil will
cause premature compressor failure.
Do not overfill.
5.
Replace oil fill plug (A)
and tighten securely.
AIR FILTER - INSPECTION AND
REPLACEMENT
Compressor heads are exposed
when filter cover is removed.
Allow compressor to cool prior to
servicing.
not operate the air compressor with
the air filter removed.
A dirty air filter will not allow the com-
pressor to operate at full capacity.
Keep the air filter clean at all times.
1.
Remove
the air filter
cover.
2.
Remove
the air filter
from filter
cover.
IMPORTANT:
Do not oper-
ate the compressor with the air filter
removed.
3.
Place new air filter into filter cover.
Refer to the Repair Parts for the
correct part number.
4.
Replace air filter cover and lock
into place.
BELT - REPLACEMENT
Risk of personal
injury. Serious injury or damage
may occur if parts of the body or
loose items get caught in moving
parts. Never operate the outfit
with the belt guard removed. The
belt guard should be removed only
when the air compressor power is
disconnected.
1.
Turn air compressor off, lock out
the power supply, and relieve all
air pressure from the air tank.
N001248
Hot surfaces.
Risk of burn.
Keep the air filter
clean at all times. Do
Air Filter
Cover
2.
Remove the front of the belt
guard by disengaging the snaps.
Insert a flat bladed screwdriver
at each snap location and
pry the beltguard apart.
3.
Loosen the wing nut on hold
down plate and tilt motor
to allow for easy removal or
installation of the belt.
4.
Remove belt.
Use caution when rolling belt onto
flywheel, fingers can get caught
between the belt and flywheel.
Replace belt. NOTE: The
5.
belt must be centered over
the grooves on the flywheel
and motor pulley.
Wing Nut
6.
Turn the wing nut on the hold
down plate until it makes
contact with the washer,
plus one additional turn.
7.
Replace the belt guard
18-ENG
Belt Guard
Risk of moving parts.
.
Publicidad
