Publicidad
Idiomas disponibles
Idiomas disponibles
To Drain Tank
NOTE: Operation of the air
compressor will cause condensation
to build up in the air tank. Always
drain tank on a washable surface or
in a suitable container to prevent
damaging or staining surfaces.
1.
Set the On/Auto/Off lever to
"OFF".
2.
Close the globe valve.
3.
Remove the air tool or
accessory.
4.
Open the globe valve and allow
the air to slowly bleed from the
air tank until tank pressure is
approximately 20 psi.
5.
Close the globe valve.
6.
Drain water from air tank by
opening drain valve (counter-
clockwise) on bottom of tank.
tank. If not drained, water will
corrode and weaken the air tank
causing a risk of air tank rupture.
7.
After the water has been
drained, close the drain valve
(clockwise). The air compressor
can now be stored.
NOTE: If drain valve is plugged,
release all air pressure. The valve
can then be removed, cleaned, then
reinstalled.
Oil
NOTE: Use a air compressor oil such
as SAE-30 (API CG/CD heavy duty
motor oil. Under extreme winter
conditions use SAE-20 weight oil.
NOTE: Crankcase oil capacity is
approximately 60 fluid ounces (1.8 l).
Checking
1.
The oil level should be to the
middle of the sight glass (C).
2.
If needed remove oil fill plug (A)
and slowly add oil until it reaches
the middle of the sight glass.
D26056
Water will
condense in the air
Changing
1.
Remove the oil fill plug (A).
2.
Remove the oil drain plug (B) and
drain oil into a suitable container.
3.
Replace the oil drain plug (B) and
tighten securely
4.
Sowly add compressor oil until
the oil level is in the middle of the
sightglass (C). NOTE: When
filling the crankcase, the oil flows
very slowly into the pump. If the
oil is added too quickly, it will
overflow and appear to be full.
premature compressor failure. Do
not overfill.
5.
Replace oil fill plug (A) and
tighten securely.
18-ENG
A
C
C
B
Overfilling with oil
will cause
Publicidad
