Publicidad
Idiomas disponibles
Idiomas disponibles
Proper use
The adjustable welding angle with TMC 300 magnetic clamp is a unit equipped with two switchable magnetic
clamps, which is designed to position and to align different ferromagnetic, metallic work pieces to each other. It
may only be used according to its technical data and determination. Proper use includes adherence to the start-up,
operating, environment and maintenance conditions specified by the manufacturer. The user bears sole
responsibility for understanding the operating manual as well as for proper use and maintenance of the adjustable
welding angle with magnetic clamp TMC 300.
Device description
The adjustable welding angle consists of two TMC 300 magnetic clamps (B), whose angle to each other can be
modified according to desire and application. Any angle between 0° and 90° can be adjusted exactly at the read-
out point (E) and fixed by means of the angle scale (F). All 3 clamping levers (C) must be opened and/or tightened
to adjust and fix the angle. For use in small, cramped installation spaces the clamping levers can be replaced by
the enclosed mild steel screws and fixed with the insertable Allen key (I).
The TMC (Thin Material Clamper) is a switchable magnetic clamp with manual actuation for attachment to
ferromagnetic materials. The magnet can be activated by pushing the activation lever (A) into the ON position until
it audibly latches into place. The installed permanent magnet generates a magnetic field in the lower magnetic
plate area (D). Owing to the special design of the TMC 300, this magnetic field is very compact and develops
excellent adhesive force especially on thin materials of less than 10 mm. The activation lever must be lifted slightly
at its end and returned by 60° into the OFF position in order to deactivate the magnet. Care must be taken that the
lever springs back strongly when working on thin materials.
Be sure to read the operation instructions completely before using the magnet for the first time!
A) Activation lever for magnet
B) TMC 300 Magnetic clamp
C) Clamping lever for rotation
D) Magnetic surface
E) Read-out point for angle scale
F) Angle scale
G) 90° end stop
H) Clamping washer
I)
Allen key 5mm
11
Publicidad
