Publicidad
Idiomas disponibles
Idiomas disponibles
TO CLEAN AIR FILTER
1. Remove cover.
2. Carefully
remove cartridge.
3. Clean by gently tapping on a flat sur-
face. If very dirty, replace cartridge.
,_CAUTION:
Petroleum solvents,
such
as kerosene, are not to be used to clean
cartridge. They may cause deterioration
of the cartridge.
Do not oil cartridge. Do
not use pressurized
air to clean or dry
cartridge.
4.
Install cartridge, then replace cover.
Tab
Cartridge
Filter cove
MUFFLER
Inspect and replace corroded muffler as it
could create a fire hazard and/or damage.
SPARK PLUG
Replace spark plug at the beginning
of
each mowing season or after every 100
hours of operation,
whichever
occurs
first. Spark plug type and gap setting
are shown in the "PRODUCT
SPECIFIC-
ATIONS" section of this manual.
CLEANING
IMPORTANT:
For best performance,
keep mower housing free of built-grass
and trash. Clean the underside of your
mower after each use.
• I,CAUTION:
Disconnect
spark plug wire
from spark plug and place wire where it
cannot come in contact with plug.
• Clean the underside of your lawn mower
by scraping to remove build-up of grass
and trash.
• Clean engine often to keep trash from
accumulating.
A clogged engine runs
hotter and shortens engine life.
• Keep finished surfaces and wheels free
of all gasoline, oil, etc.
• We do not recommend
using a garden
hose to clean the outside of your lawn
mower unless the electrical system,
muffler, air filter and carburetor are cov- 15
ered to keep water out. Water in engine
can result in shortened
engine life.
WATER WASHOUT
FEATURE
Your lawn mower is equipped with a fitting
that allows quick and easy cleaning of
the underside of the housing.
To use this
feature, proceed as follows:
1. Move lawn mower to an area of cut
grass or another hard surface.
NOTE: Water, grass and other debris will
drain from beneath the mower housing
during the washout process.
2.
Remove grass catcher and discharge
chute assembly from lawn mower.
3. Close mulcher door (if equipped).
4. Connect a garden hose to the fitting
where shown.
IMPORTANT:
Be sure the garden hose is
not routed under the lawn mower housing
or entangled
in the wheels.
5. Turn on water supply and check for
leaks at the fitting.
If no leaks are present, start engine (as
described
in the Operation section of this
manual) and let engine run until the under-
side of the lawn mower is clean.
• i, WARNING:
Do not engage the drive
system during the washout process.
6. Shut off the engine.
7. Shut off water supply and remove hose
from fitting.
CAUTION:
Do not remove hose from
fitting while engine is running.
Water in
engine can result in shortened
engine life.
8. Start engine (as described
in the Op-
eration section of this manual) and let
engine run for a full minute to remove
excess water from mower.
Hose
Fitting
CLEAN
UNDER DRIVE COVER
Clean under drive cover at least twice a
season. Scrape underside of cover with
putty knife or similar tool to remove any
build-up of trash or grass on underside
of drive cover.
Publicidad
