Publicidad
Idiomas disponibles
Idiomas disponibles
How to Set the Door Alarm,
You don't have to set the visual
alarm. As long as either door is
open, the red DOOR OPEN
signal light flashes
DOOR OPEN
If the signal
light on the
DOOR ALARM pad is glowing,
the beeper
alarm is set. tf it's not,
touch the pad to turn it on
If either door is open for more than
30 seconds, a recurring beep sounds
The light goes out and the beeping stops when you close
the door_
ONfOFF J
There are times when you'll want the Door Alarm
beeper
turned off. When you're rearranging
a lot of
food, for example. Just touch the pad** The light wilt go
out and the beeping win stop
Deactivating the Door Alarm beeper does not turn the
red DOOR OPEN light off-it keeps flashing until the
door is closed
How the Electronic Alert
and Diagnostic System Works,
The word NORMAL is lighted
except when a failure has
been detected.
NORMAL
The SYSTEM CHECK-RESET
pad has two functions:
1 .You can touch the SYSTEM
CHECK-RESET pad and get a
review of the electronic diagnostic
codes in order of their priority.
/ CHECK /1
L
RESET
JI
2.You can touch the SYSTEM CHECK-RESET pad to
erase three flashing codes immediately and two codes
after the condition that caused them to flash has been
corrected (see the next page)
(continued next page)
Why the Red Warm
Tern peratu re Lig ht G Io-ws.
At first, it's probably
because
your newly installed refrigerator
hasn't completely cooled down
yet. Wait a few hours for it to coo!,
and then the light will go out
WARM TEMP
From then on, the red light will glow whenever
temperatures inside get too high for proper food storage
tf this happens, open the doors only when absolutely
necessary, and close them as quickly as possible
As soon as inside temperatures return to normal, the light
goes ouL
If the WARM TEMP light reappears and stays on for
longer than 4 hours, call for service
Publicidad
