GE 22 Manual Del Propietario E Instalación página 20

Installation Instructions
REVERSING THE DOOR SWING
(CONT.)
[] TRANSFER CENTER HINGE
BRACKET TO THE LEFT
]_.emove the (enter hinge bracket by removing
the three screws,
NOTE: Keep these screws with the hinge bracket.
They are long screws and will be used when installing
the hinge on the other side.
Remove the mullion cover fl'om the left side using
the thin fiat blade. Assemble it to the right side.
Remove the screw from the left side of the cabinet.
Screw it into the hole on the right side.
Place the hinge bracket over the holes at the
center left side of the cabinet. Insert and tighten
the three long screws.
Replace the cap by snapping it over the screw with
yore" finger.
[] TRANSFER DOOR STOPS
On each d()(m remoxe the door stop on the right side
of the bottom of the door bx remoxino the two screws.
• 0
Install the door stop on the left side.
Bottomof Door
(RightSide)
Bottomof Door
(Left Side)
[] TRANSFER FRESH FOOD
DOOR HANDLE TO THE RIGHT
Stainless steel handle:
O Renl(we the two
screws holding the
handle m the top of
the dora: I,oosen the
set screw with the
3/32" Mlen wrench
(supplied) and remove Plu
the handle, 0 Remove Button
the handle fastener
with the. /lb Mlen
wrench (supplied).
Transter the
ti_stener to the right
side and move the plug
button to the left side
ot the fl'esh food dora:
Plastic hmadle:
Remove the two
scrmvs holding the
handle to the top of
the dora: _ Slide the
handle up on the
ti_stener and remove Plug
the handle, _ Remove Button
the handle fastener
with the 3/16" Mien
wrench (supplied).
Tmnstbr the
ti_stener to the right
side and move the
plug button to the left side of the fl'esh ti)()(1 doo_:
After removing the handle: Move the small plug
buttons fl'om the top right side of the door top and
insert them into the holes on the opposite side,
Small P lu,
Buttons
Move the large plug button fl'om the left edge of the
door and insert it into the hole on the opposite side.
PlugButton
I
2O