Horizon Global 3081 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing wiring harness
1. Locate the vehicle's electric brake control harness connector.
Remove the driver's side kick panel. There will be a 4-pin
connector that mates with the brake control harness taped to
another vehicle harness. Connect the brake control harness
into the vehicle's connector being careful to not break locking
tabs.
2. Plug the brake control adapter into the vehicle electric
controller connector.
3. Complete the installation per the electric brake control
manufacturer's instructions and mount the unit as directed.
Perform test procedures as instructed.
NOTE:
Vehicles not equipped with OEM trailer tow package, may
require fuses and relays to complete output & battery feed
circuits (sold separately). Consult owner's manual for locations.
Overloading circuit can cause fires. DO NOT exceed lower of
towing manufacturer rating or: • Max.4 axles: 8 brakes (24
amps). Read vehicle's owners manual and instruction sheet for
additional information.
©2023 Horizon Global™ Corp
Installation Instructions
PART NUMBER: 3081
A
Sheet 3 of 12 3081-N 4/13/2023 Rev. A