Section 4: Opecation
9.
Engage trigger Hockto spraygun trigger (Figure iO).
i 0. When
starting
engine, position
yourseif
as recommended
in Figure
i i and start
engine according
to instructions
given in engine operator's
manuaLAiso
see operating
instructions
tag iocated
on the pressure
washer.
..... -.......
Oo o0
1
//fl
----_
.......
WARNING
ALWAYS point gun in safe direction
and squeeze spray gun
trigger; to release pressure and avoid kickback each time,
before starting engine.
When
starting engine, puli cord slowiy und[ resistance is felt
and then pull rapidly to avoid kickback.
After each starting attempt, where engine faiis to run, always
point gun in safe direction
and squeeze spray gun trigger to
release high pressure,
NOT_=:
Always
keep the chrotde
lever
in the "Fast"
position
when
operating
the pressure
washer.
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment
to cool before touching.
Keep at ieasC 5 ft, (152 cm) clearance on all sides of pressure
washer
including overhead.
Code of Federal Regubdon
(CFR) Titie 36 Parks, Forests, and
PuNic Property
require equipment
powered by an internal
combustion
engine to have a spark arrester, maintained
in
effective working
order, complying
to USDA Forest service
standard 5100- [ C or iater revision, in the State of California
a
spark attester
is required under section 4442 of the California
PuNic resources code. Other
states may have similar laws.
How
to
StopYour
Pressure
Washer
I.
Let engine
idle for two
minutes.
2.
Turn
engine
off according
to instructions
given in
engine
operator's
manual
3.
ADA/AYS
point
gun in a safe direction
and squeeze
spray gun trigger
to release
retained
high water
pressure.
WANNING
Keep high pressure hose connected
to pump and spray gun
whiie system is pressurized.
ALVVAYS point gun in safe direction
and squeeze spray gun
trigger, to retease high pressure, every time you stop engine.
Engage trigger loc!( when not in use,
4.
Engage trigger loci< on spray gun when not in use.