Publicidad
Idiomas disponibles
Idiomas disponibles
[] Basic Connection
Thissection describes h owto c0nnect t he unit toan antenna,cable/satellite box, e tc.
Note:
• Besure your an tenna or other device is connected properly before plugging in the power cord.
[Antenna
Cable Connection]
When connecting
the unit to an antenna
or cable TV company
(without
cable/satellite
box)
Connect
the RF coaxial cable on your home outlet to the antenna
input jack of this unit.
e.g.)
VH F / UHF'_
antenna
_ "
RF coaxial
cable
rear of this
unit
cableTV
company
_Once connections
are completed,
turn on the unit and begin initial setup.
Channel
scanning
is necessary for the unit to memorize
all available
channels
in your area.
(Refer to"Initial
Setup"on
page 10.)
Note:
• Foryour safety and to avoid damage to device, please unplug the RFcoaxial cable from the an tenna input jack before moving the unit.
• If you use an antenna to receive analog TV,it should also work for DTV reception. Outdoor or attic antennas will be more effective than
settop versions.
• To easily switch your reception source between antenna and cable, install an antenna selector.
• fyou connect to the cable system directly, contact the CATVinstaller.
[Connection
to Cable Box or Satellite
Box]
Connect
the RF coaxial cable on your home outlet to the input jack of the cable/satellite
box.
Use another
RFcoaxial cable to connect
the antenna
input jack of the unit to the output
jack of the cable/satellite
box.
e.g.)
satellite
dish
cable/satellite
box
rear of this unit
RF OUT
coaxial
cable
RF coaxial
cable
_Required cables and connecting
methods differ depending
on the cable/satellite
box.
For more information,
please contact your cable/satellite
provider.
EN
Publicidad
