Crena CEA-YC688 Manual De Instrucciones página 3

Use Instruction
1. Take off the card board and protective membrane of the soleplate and clean it
with a soft cloth if it's you first time to use it. Put the pedestal on a stable place
and put the iron on the iron bracket. Always put the iron on the iron bracket to
avoid any damage caused by the hot temperature even you just break off during
the usage.
2. Supplying water (we recommended distilled water). Unplug the device, unscrew
the water inlet cap. Fill water with assorted cup to indicated water line. Make
sure that do not fill too much water. If some water comes out, swab up with soft
cloth and then screw the water inlet cap.
3. According to the hint on the tag of cloth to adjust the temperature control knob.
To iron from low temperature cloth if there's variety clothes.
4. Heating: insert the plug in the wall outlet and both the indicator lamp of
evaporator and iron light on. The indicator lamp of iron will go out automatically
when the temperatures come to a certain degree. And when the temperature
below the degree, it will light on again. It takes about 7 minutes to heat, and the
indicator lamp of iron goes out. It's ready for ironing.
5. Steam ironing: the max steam volume can be used only when the iron
temperature is higher than middle rail or there will be drip tile from the soleplate.
To make steam jet come out, press the steam button. To obtain a continuous
steam jet, press and push backwards the steam cage knob. To stop using, just
push ahead and release the steam cage knob.
6. Vertical steam ironing: adjust the temperate to highest when have vertical
steam ironing, the steam volume can be adjusted according to your need.
7. Dry ironing:
1) When the device is cool down, adjust the temperature needed, insert the plug.
When the indicator lamp of iron goes off second time(about 4 minutes), you can
start dry ironing.
2) When the device is during usage, turn off the steam switch and adjust the
temperature, it's ready for ironing.