Crena CEA-YC688 Manual De Instrucciones página 4

Supplying water while operating
Unplug the device from the wall outlet, twist off slowly the water inlet cap and
supply the water as the first time. Screw the water inlet cap after fill the water and
insert the plug. The device is wording. When the indicator lamp of iron goes off, you
can iron again.
Cleaning and maintenance
1. After usage, release the steam button, unplug the device, put the iron on the
iron bracket, you can house when it completely cool down.
2. Clean the surface of device: use soft and wet cloth with little detergent to
clean the surface. Do not clean it in water or other liquid and do not rinse it
under tap.
3. Do not wipe the soleplate with acetone or other organic solvent for it will
damage the polish of the surface. To clean the hole with soft needle if there's
any impurity.
4. To clean the device only with clean water and tipped off the water after clean.
To make sure not use detergent, perfume or other chemic liquid to clean the
boiler.
PROBLEM
There's white flour coming
out from the new iron
soleplate
There's drip when steam
jetting
There's no stem come out
from evaporating
chamber
There's no steam come
our from iron
The soleplate is dirty
Possible Cause
It's normal as the iron is
new
When you start steam
ironing, the steam fitter is
still cool, and the steam
will cool down, so there
will be water come from
soleplate
You haven' turned on the
steam adjustor or there's
no enough water in the
water tank.
Steam with too high
temperature cannot be
seen, especially when the
iron temperature is also
be adjusted to be highest
and the room temperature
is also very high.
There's impurity and
chemic material in water
exhibiting one the
soleplate or the
temperature is too high
for the clothes.
Treatment
The flour is not harmful,
and after several usage, it
will not appear again.
It's normal. To put the iron
on an old cloth, and press
the steam button. The
cloth will absorb
water. After several
second, the steam jet will
be OK
To make sure the supply
of power. Supply enough
water and wait until the
indicator lamp of iron goes
off.
Put a mirror under the
working soleplate
check if there's steam out
from soleplate.
Clean the soleplate with a
sot and set cloth and
adjust the temperature to
a suit degree.
the
and