Power smart PS76821 Manual De Instrucciones página 25

TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE
The battery is not charged.
The switch is defective.
Grass jammed at blade.
The mower does
not start.
The battery is not attached to
the motor.
Battery may require service or
replacement.
The lawn is rough or uneven.
The mower cuts
the grass unevenly.
The cutting height is not set
properly.
Wet grass clippings are sticking
The mower does
to the underside of the deck.
not mulch properly.
The side discharge is missing.
The grass is too tall, or the
cutting height is too low.
The mower is hard
The rear of the mower housing
to push.
and the blade are dragging in
thick grass.
The motor shaft is bent.
The mower is
excessively noisy
The blade is unbalanced.
and vibrates.
SOLUTION
Charge the battery.
Replace the switch
Remove battery; check under deck for
jams.
Check the connection between the motor
connector and the battery.
Call customer service 1-800-791-9458
or replace battery.
Check the mowing area.
Move the wheels to a higher setting.
Wait until the grass dries before mowing.
Install the side discharge.
Raise the cutting height.
Empty the grass clippings from the grass
catcher bag.
Stop the motor, and inspect for damage.
Repair before restarting. If vibration
persists, call customer service at 1-800-
791-9458
25