Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly & Operation
Unpacking
Your Ash Vacuum & General Assembly
B
D
D
(Continued)
,_
ARNING: Do not plug in power cord to power outlet, make sure plug is
disconnected
before assembling
the ash vacuum.
1. Remove the ash vacuum from the
package.
2. Unlock the latches and remove the
power head lid. (Fig. 1)
3. Remove the contents
from inside
the collection
tank (Fig. 2) and make
sure you have all the parts listed on
page 6.
4. Place the pre=filter and power head
lid on the collection
tank and secure
with the latches. (Fig. 3)
5. insert the locking end of the hose
onto the vacuum port. (Fig. 4)
6. insert the aluminum wand into the
other end of the hose. (Fig. 5) insert
the crevice tool onto the hose for
vacuuming
narrow spaces.
7. Connect the power cord to the outlet
(Fig. 6) and turn the vacuum cleaner
power switch to the 'l' ON position.
(Fig. 7)
8. Run the unit for 30 seconds after you
have finished cleaning your stove
or fireplace to ensure all materials
are safely captured
in the collection
tank.
9. Once you have completed
vacuuming,
press the power switch
to the 'O' (OFF) position and unplug
the power cord from the outlet.
CAUTION:
Never use ash vacuum
without the aluminum wand, crevice
tool, or mini hose in place.
WARNING:
Be sure to read, understand
and apply all the information in the
important
Safety instructions
section at the beginning of this operator's
manual.
Do not vacuum in areas with flammable
gases, vapors, or explosive
dusts in the
air. Flammable
gases or vapors include but are not limited to: lighter fluid,
solvent type cleaners, oil=base paints, gasoline, alcohol,
or aerosol sprays.
Explosive dusts include but are not limited to: coal, magnesium,
grain, or gun
powder.
To reduce the risk of health hazards from vapors or dust, do not
vacuum toxic materials.
Publicidad
