Velleman MML24CN Manual Del Usuario página 5

1. Press [RUN PAGE].
2. Press [A to Z] to select the "select run" pages. Press [ENTER] to confirm.
3. Enter the pages you want to run, e.g. [A] [B] and [C] to run page A, B and C.
4. Press [ENTER] to run the message.
Resetting the system using the [FUNCT] key
1. Press [FUNCT] to enter the setup function.
2. Press [↓] to clear all. [Clear all Y] appears. Press [ENTER] to confirm.
Setting the ID address using [FUNCT]
1. Press [FUNCT] to enter the setup function.
2. Press [↓] [↓] to select [ADD00].
3. Press [→] [←] to select the address field.
4. Press [↑] [↓] to edit the address from 00 to ZZ.
5. Press [ENTER] to confirm. Press [ESC] to return to the normal display.
Setting the brightness using [FUNCT]
1. Press [FUNCT] to enter the setup function.
2. Press [↓] [↓] [↓] to enter the brightness function.
3. Press [→] to select the brightness field.
4. Adjust the brightness from high to low using [↑] [↓].
5. Press [ENTER] to confirm. Press [ESC] to return to the normal display.
Setting the system clock using [FUNCT]
1. Press [FUNCT] to enter the setup function.
2. Press [↓] [↓] [↓] [↓] to set up year data.
3. Press [→] [←] to select the year field.
4. Enter the year using [↑] [↓]. Press [ENTER] to confirm.
5. Press [↓] to switch to month data.
6. Repeat steps 3, 4 and 5 and enter the month, day, hour and minute.
7. Press [ESC] to return to the normal display mode.
7. Software
7.1. PC system requirements
• Operating system: Win98/WinME/WinNT/Win2000/WinXP
• CPU: Pentium 166 or above
• RAM: 32 MB or above
• Monitor: VGA or higher
• Serial output: RS232 port
7.2. USB RS232 Converter
The USB RS232 converter can convert a USB1.1 interface to an RS232 serial interface.
Installing the Drivers
The enclosed CD-ROM contains the converter port drivers. The drivers are located at \usb driver\WIN on the CD-
ROM.
MML24CN/MML24R_v5 5 VELLEMAN