Publicidad
Idiomas disponibles
Idiomas disponibles
RAW Series
PARTS DESCRIPTION
A. ON / OFF
B. Power selector
C. Timer
D. Wheels
E. Supports
ASSEMBLY OF THE RAW SERIES
The oil radiator is packed with the wheels not assembled. Please make sure that they are right
assembled before turning the device on. Remove the heater and all the accessories from the carton.
1- Turn the radiator upside down carefully and place it over a carpet or any other soft surface in order
not to damage the unit.
2- Pass the "U bolt" in between the last and next-to-last fin and make it fit the holes of the curved
support. Screw the U bolt to the curved support with the help of the wing nuts. Then, screw the
wheels to the support. See picture below.
3- Repeat step 2 in between the first and the second fin, using the curved support.
4- Turn the heater the right way up. The unit should be as shown in the picture in "parts description"
section.
NOTA:
Depending on the model, it can incorporate one of the curved supports or even both. In case
of having a curved support, this would be installed in the front part of the radiator.
STARTING THE RADIATOR
Place the radiator on the floor at least 1 m away from the wall or other objects such as furniture,
curtains or plants (make sure the power supply socket you are going to use meets the requirements
specified on the radiator data plate) .
Conect the radiator to the main socket.
13
Publicidad
