Publicidad
Idiomas disponibles
Idiomas disponibles
• SKIP UP: Press this button once to play the next file, press and hold this button to fast forward
through the files/tracks.
• SKIP DOWN: Press this button once to play the previous file, press and hold this button to fast
reverse through the files/tracks.
• REPEAT CD/USB/SD Playback: press and hold this button to one & All repeatedly
Removing the USB device / SD card
• First move the function selector to another mode (tuner, phono, tape), then tap the
POWER/VOLUME knob to turn off the power.
• To remove a USB device, pull it out of the USB port.
• To remove a memory card, press the memory card inwards and then release it. The card will
be released (partially ejected) and you can remove it by hand.
Important Notes
• The system can only detect and read files in MP3/WMA format via the USB port or SD card
slot.
• You can connect an MP3 player to the system via the USB port, however, some MP3 players
may not be able to play via the USB socket. This is due to variances in the MP3 encoding
format; it is not a malfunction of the system. There are numerous USB and SD device
producers and their products vary in solution and format. We therefore cannot guarantee that
this unit will support all USB and SD devices from every brand.
• This system supports SD cards up to 8GB.
• MP3 / WMA track format requirements:
o MP3 bit rate: 32 kbps~256 kbps;
o WMA bit rate: 32 kbps ~ 320 kbps.
Programming MP3/WMA Tracks for Playback
Up to 99 tracks can be programmed for MP3 / WMA file playback in any order. Before programming,
however, be sure the system is in STOP mode.
1) Set the function selector to USB/SD mode, then press the stop
2) Press the program PROG button, MEM will be flashing on the LC display, and it will indicate
the program number and digits for the track number to be programmed.
3) Press the skip up
4) Press the program PROG button to store the track into the memory.
5) Repeat steps 3 and 4 to enter additional tracks into the memory.
6) When all desired tracks have been programmed, press the PLAY/PAUSE
tracks in the assigned order.
7) To cancel programming, press the STOP button
Using the CD Player
1) Tap the POWER/VOLUME knob to turn the equipment on.
or skip down
button to select a desired track.
twice.
-8-
button.
button to play the
Publicidad
