Publicidad
Idiomas disponibles
Idiomas disponibles
Contents
of Carton
1 - Air Compressor
2-
Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Molded Foot Bumpers
2 - Screws, 1/4 x 1-1/2
1
Handle
1 - Handle Grip
2 - Screws, #10-16 x 1
Tools Required for
Assembly
1 - 9/16" socket or open end
wrench
1 - 3/8" socket
Installing
Handles,
Wheels,
and Molded
Foot
Bumpers
_The
wheels
and handle
do not provide adequate clearance,
stability
or support
for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
1.
Submerge handle grip into warm
soapy water to make installation
easier. Remove handle grip from
soapy water and slide onto
handle.
2,
Slide handle through holes in
compressor saddle onto tabs.
Secure with screws, one on each
side.
_lt
will be necessary
to brace or
support
one side of the outfit when
installing
the wheels because
the
compressor
will have a tendency
to
tip over.
3.
Install one shoulder bolt
and one nut for each wheel.
Tighten securely. The outfit
will sit level
if the wheels are
properly installed.
\\\
\
Wheel
Nut
/
4,
Shoulder
Belt
Clean and dry underside of
air tank leg opposite wheels.
Remove the protective strip from
the adhesive backed molded
foot bumpers. Attach the foot
bumpers to the bottom of leg
on each end.
Press firmly into
place.
Molded
1000001267
10-ENG
Publicidad
