Publicidad
Idiomas disponibles
Idiomas disponibles
External AVS 75 expansion module - Accessory
2. SUPPLY
Accessory AVS 75 is made up of:
3. INSTALLING THE EXPANSION MODULE
The expansion module is to be connected in an electrical cabinet.
It can be mounted on DIN rail or with fixing screws.
Screwwed
4. ELECTRICAL CONNECTION
4.1. Cable section
Cable sections below are purely illustrative and do not relieve the installer from checking
that they meet requirements and satisfy the national and local standards in force.
If a cable is damaged, it must be replaced by the manufacturer, its after-sales service or
a similarly qualified person to avoid any possible danger.
This device is designed to operate at a nominal voltage of 230V, +10% / -15%, 50 Hz
Cable
Power supply
BSB communication bus betveen AVS75
Valve
Pump
Sensors
"0 ... 10V" input / "On/Off"
BSB communication bus with Navistem
Page 8 /18
• 1 expansion module
• 2 fixing screws (M4 x 16)
• 1 BSB bus communication cable
• 1 BSB bus communication wiring for connection to the Navistem
• 1 heating flow sensor
DANGER:
Vissé
2 x 0,5 mm² (lg 200 m maxi)
Prior to any work, ensure that the electrical supply is
cut off.
A : Montage
Assembly
Copper conductors
3 G 1,5 mm² (6A maxi)
provided
4 G 1,5 mm² (2A maxi)
3 G 1.5 (2A max)
2 x 0,5 mm²
Din rail
Sur rail DIN
/
B : Démontage
Disassembly
Cable raceway
High current
Low current
High current
High current
Low current
Low current
00U07325080-B
Publicidad
