Descargar Imprimir esta página

Brandson Equipment 301812 Manual De Usuario página 12

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

By briefly pressing the "Y-M-D" key, you can switch between the display of the time
and the date. By briefly pressing the "Projection ON/OFF" button, it is also possible
to flexibly switch the projection on or off.
6 Setting the time and date
After connecting the device to a properly connected power outlet, press and hold
the "MEM/M+/NAP" button until the year flashes in the display to set the time and
date. Use the "Transmitter Forward" and "Transmitter Back" buttons to increase
or decrease the numbers. In Settings, briefly press the "MEM/M+/NAP" button to
confirm the setting and set the next item in the setting cycle.
1. Year
2. Month / Day
3. Hour / Minute
Note: To activate Daylight Saving Time (DST), press and hold the "Snooze/Sleep"
button in standby mode. The time in the display will change one hour forwards or
backwards accordingly.
7 Setting the wake-up time
Press one of the two "Alarm" buttons (Alarm1 / Alarm2) to display the alarm
time. Then press and hold the button to enter the alarm time settings. The
alarm time will start flashing. By briefly pressing the "Transmitter Forward" and
"Transmitter Back" buttons, you can set the alarm time. Press the corresponding
"Alarm" button to confirm your setting. The setting cycle is as follows:
1. hour/minute
2- weekdays (options: 1-5, 1-7, 6-7, 1-1)
3. alarm tone
If you prefer the radio function, select the currently set frequency (for how to set
it, refer to section 11 of this manual). If you prefer the beep function, select bu.
4. radio volume alarm (01-15) - This function can only be selected if you select the
radio function as the alarm tone.
The following table on the next page shows the weekday settings:
12
English

Publicidad

loading