Nevadent NMD 3.7 C8 Instrucciones De Uso página 11

Setting up the appliance / wall mounting
Note
► The charging station
Place the charging station
► In damp rooms, especially in the vicinity of water (bath), the charging station
must be firmly fixed to the wall to protect it from falling into the water.
► Before wall mounting, make sure that there are no cables or pipes in the area
where you want to hang the charging station
1) Mark two drill holes on the wall 3.3 cm apart and drill the marked holes with a
5 mm bit. Ensure that there is a mains power socket in the immediate vicinity.
2) Push the supplied wall plugs into the drill holes and screw the screws into the wall
plugs. Take care that the screws still protrude about 3 mm out of the holes.
3) Feed the power cable through one of the recesses
q
station , depending on which side the power socket is located.
4) Push the charging station
8
hangers at the back of the charging station
down so that the screws slide into the rails of the hangers
q
station sits firmly on the screws.
│ GB │ IE
■ 8
q
may only be operated free-standing if used in dry rooms.
q
on a horizontal, level and stable surface.
q
onto the screws so that the screws protrude into the
q
.
0
on the side of the charging
q
. Then press the charging station
8
and the charging
q
q
NMD 3.7 C8