Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Wait until the blade fully stops before you start the
machine again. Do not quickly turn the machine off
and on.
Always remove the safety key and battery pack after
you complete the work.
5.3
EMPTY THE GRASS CATCHER
1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge flap and hold it.
5. Hold the grass catcher by its handle and unhook it
from the slots.
6. Close the rear discharge flap.
7. Empty the grass catcher.
5.4
OPERATING ON SLOPES
Do not mow on slopes with incline more than 15°. If
you are not comfortable, do not mow on a slope.
•
Do not go up and down on a slope, mow across the
face of the slope. Be careful when you change the
direction on a slope.
•
Monitor holes, roots, rocks, and other hidden objects
that can cause you to fall. Remove all obstacles
such as rocks and tree limbs.
•
Make sure that your footing is stable. If you are out
of balance, release the handle switch immediately.
•
Do not mow near drop-offs, ditches, or
embankments.
5.5
OPERATION TIPS
•
Do not try to override the operation of the start
button or handle switch.
•
Do not tilt the machine when you start it.
•
Do not put hands or feet near or below the turning
parts.
•
Keep the discharge chute clean.
•
Do not cut wet grass.
•
Higher blade height is necessary for new or thick
grass.
•
Clean the bottom of the mower deck after each
use. Remove grass clippings, leaves, dirt, and other
debris.
WARNING
WARNING
WARNING
English
6
MAINTENANCE
Remove the safety key and battery pack from the
machine before maintenance.
Keep the engine and battery pack free from grass,
leaves or too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
6.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
•
Tighten correctly all the fasteners and caps.
•
Clean the machine with a dry cloth. Do not use
water.
6.2
REPLACE THE BLADE
Figure 10
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade
when you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Wedge a piece of wood between the blade and
mower deck to prevent the movement of the blade.
6. Untighten the mounting bolt and remove the
spacers.
7. Remove the blade and replace with a new one.
6
WARNING
WARNING
CAUTION
CAUTION
CAUTION
WARNING
WARNING
Publicidad
