LEGRAND C2G Manual página 9

HDMI® HDBaseT + USB-B to A and RS232 over Cat Extender Box Transmitter to
Box Receiver (18Gbps) - 4K 60Hz up to 328ft
Upgrade
The transmitter and receiver support upgrading FW through RS232 port on rear panel. Please contact your supplier to get the
latest upgrade tool, "Legrand Product Firmware Updater."
Steps to upgrade FW:
1. Connect the RS232 port of the transmitter/receiver to the PC using a 3-pin phoenix connector to USB type-A cable.
2. Set the DIP switch of the transmitter/receiver to the position of "X, X, Down, Up".
3. Connect the power adapter provided to the receiver. Power on all attached devices.
Note: If the transmitter isn't connected with the receiver, it needs to be connected to another power adapter.
4. Open the "Legrand Product Firmware Updater" software. The interface of the software is as follows on page 8.
(Step 5 continued on page 9)
7
(us)
(us)