Publicidad
Idiomas disponibles
Idiomas disponibles
How To Use
Battery indicator
Sensor mode indicator
How to use the Power key
One key to switch between � working modes.
➀Wireless Use
Press
to enter sensor mode
again to turn off
➁Wired Mode
Press
to enter sensor mode
again to turn off
Sensing Mode
When battery power is on, water is activated when the pet is near
When the power cord is plugged in, water is dispensed when the pet is near; water is
automatically released for �� seconds if no sensing is done within �� minutes.
Sensing angle: ���-���°, Sensing distance: �.�m
Note: Sensitivity is affected by ambient temperature.
Intermittent Mode
Intermittent mode is activated when the battery is powered; water is dispensed for �� seconds at
�� minute interval.
Continuous Mode
You can start the continuous mode when the fountain is plugged into the power cord. The water
pump shall keep working all the time
Note: Continuous mode does not support wireless use.
Filter Cartridge Replacement Notification
When the indicator light flashes, the filter cartridge needs to be replaced (water pump operation
time is more than ��� hours).
After replacing the filter cartridge, please press the power button long after the power is turned
on for � seconds to reset successfully.
→ press
again to enter intermittent mode
→ press
again to enter continuous mode
��
Power button
Continuous mode/Intermittent mode indicator
Filter cartridge replacement indicator
→ press
→ press
Publicidad
