makro PROFESSIONAL Metro Professional GGW1001 Manual De Instrucciones página 31

Once the cycle has started, the wash cycle
program stops and resets itself; lower the hood again to restart the cycle.
5.6 – DRAIN THE WASH TANK HOOD DISHWASHER
Do not turn off the machine while water is still in the tank. Always drain it first. When finished using the machine, after
having performed the final drainage and eventual regeneration, turn the machine off by pressing the on/off
button, deactivate the wall switch and turn off the water interception faucet. Do not leave the machine on,
inactive and unutilized for long periods of time.
6 – MAINTENANCE AND CLEANING
Even though the machine does not require any special programmed maintenance in particular, we still recommend you have it
checked out by a specialized technician twice a year.
ATTENTION: The manufacturer cannot be held liable for intentional damages or damages caused by carelessness,
negligence or from the failed observance of the prescriptions, instructions and standards or from incorrect connections or
plumbing.
The machine complies with the protection rating IPX1 and it is forbidden to use a direct jet of water to clean it.
14
CHOOSING A WASH PROGRAM:75, 120 or 180 seconds.
You can select the wash program using the cycles selector.
Lower the hood to start the wash cycle
indicator turns on. If the hood is lifted during the cycle, the
LED
Once the program has finished, the wash cycle
turns off.
Lift the hood and remove the rack.
MODELS WITHOUT DRAIN PUMP
(refer to section 2.1 Technical Specifications).
Turn the machine off by pressing
remove the overflow and wait for the tank to empty. Place
the overflow back into the tank and close the hood.
Deactivate the general wall switch.
Please note, water wash tank should be daily drained out
3-4 times.
EN
indicator
LED
, open the hood,