Publicidad
Idiomas disponibles
Idiomas disponibles
Change faceplate
1. Remove faceplate.
2. Remove backplate.
Additional UL steps (Not common)
a
BE365F ONLY: Prepare additional hole.
1 1/2" (38 mm)
b
BE365F AND BE365F20: Install UL cup.
c
BE365F ONLY: Install UL plate
3. Install drive-in
faceplate.
3/8" (8 mm)
Inside of door
Test lock
a
Lock (extend bolt).
1. Press the Schlage
button.
2. Rotate thumbturn
towards door edge.
Did bolt extend?
Yes. Lock is
installed correctly.
For troubleshooting information, go to schlage.com/faqs-keypad.
b
Unlock (retract bolt).
1. Find User Code A on
the label located on
these instructions.
2. Enter User Code A
(four digits) into the
keypad.
3. Rotate thumbturn away
from door edge.
Did bolt retract?
Yes. Lock is
installed correctly.
No. Lock is not installed correctly.
Remove lock and reinstall. Pay close
attention to cam position in 3.
No. Lock is not installed correctly.
Remove lock and reinstall. Pay close
attention to cam position in 3.
Publicidad
