Hydor KORALIA Magnum Serie Manual página 8

Do not connect to electrical supply if pump is not positioned
All manuals and user guides at all-guides.com
using the supplied suction-cup + magnet support.
The cord of this pump cannot be replaced or repaired; in case
of damage the entire unit must be substituted.
Do not cut or pull on the electrical cord.
Always disconnect from mains gently and make sure hands
are dry.
When in function, make sure that the pump surface is not
blocked.
When in function, make sure that the pump does not take in
sand, as this could seriously damage the unit and void the
guarantee (read carefully the maintenance paragraph).
Due to the high attraction level between the magnets in the
support, keep out of reach of children.
Avoid attaching the magnets directly to one-another.
Make sure you hold the magnets from the sides and avoid
placing hands or fingers in between.
At a distance up to 5 cm (2 inches) the magnets attract
metal objects and other magnets with a high force: to prevent
injuries, avoid closeness with blades, sharp objects or other
magnets.
The magnet can cause permanent damage to electrical devices
or articles that are affected by a magnetic field such as
pacemakers, credit cards, or keys: always maintain them at a
minimum distance of 30 cm (12 inches).
When not in use, always place the carton separator between
magnets.
If exposed to temperature higher than 50° C (122° F) the
magnets can lose part or all the attracting power.
Always clean the aquarium side before placing the suctions
cup + magnet support: any dirt on the surface might prevent
the suction cup from attaching properly and the pump might
slip on the bottom of the aquarium causing damage to things
and itself.
Please keep these instruction in a safe and dry place.
INSTALLATION
Attention: please verify that all components of the pump are
undamaged before putting it into function. Before any kind of
intervention, ALWAYS disconnect electrical supply of the pump
and any other appliance placed in the water. Be sure that the
voltage of the mains supply corresponds to the voltage shown on
the unit's label.
In order to prevent noise and disturbance caused by vibration we
suggest to position the pump avoiding lateral contact with the
aquarium glass or in an upward position on the bottom.
Unwind the electric cable.
Insert the cylinder on the sphere attachment to the pump in
the proper slot. -Fig. 2-
Immerse the pump completely and turn it in a vertical position
in order to allow any air to come out of the impeller chamber.
Attach the pump with the internal part of the suction cup
+ magnet support to the aquarium side as desired -Fig.
3- (remember to clean the surface before attaching the
support).
Holding with one hand the pump attached inside the aquarium,
place the external part of the magnetic support on the outside
of the aquarium at a distance of approx. 10 cm (4 inches) from
the centre of the internal support. Slowly move the external
support until you feel the attraction between the magnets and
place them so that the centres are on the same axis. -Fig. 4-
Make sure the magnet-suction cup support is well attached by
pressing the 2 parts against the aquarium glass
Direct the water flow as desired.