Publicidad
Idiomas disponibles
Idiomas disponibles
The ambient temperature during operation of the device should be in the range of 0 to 40 ° C, and the relative
humidity in the range of 10% to 90%.
Provide adequate ventilation in the place of use and make sure that the inverter is not exposed to heat from
heat sources or fire.
Always use the device on an even, stable, clean, fireproof and dry surface and out of the reach of children
and people with reduced mental, sensory and mental capabilities.
When using the mains power supply, the device must be located in such a way that the mains plug can be
reached at any time. Make sure that the power supply to the device corresponds to the data on the rating
plate!
3.3.
Device use
Turning the power on and off
Power button
To turn on the device, set the "Power on" button to the "I" position. To turn off the device, set this "Power
on" button to the "O" position.
"AC on" button
Before connecting a device supplied with 230 V AC to the inverter, set the "AC on" button to the "I" position.
To return to power to the DC sockets, turn the "AC on" button to the "O" position.
Battery charging
1)
Connect the cable of the solar panel or AC adapter to the charging socket.
2)
When charging with solar panel: Place the panel in a sunny place and adjust the angle according to
your local latitude. The best operating time for a solar panel is between 10am and 3pm.
3)
The battery indicator on the device control panel flashes to indicate that the device is being charged.
When the battery is fully charged, all battery level indicator lights will turn on.
System protection
1)
When DC overvoltage occurs or a major fault occurs, the fuse may blow and the system will
automatically turn off all DC outputs. In this case, replace the 10 A fuse.
2)
If the 230V AC output terminal is overloaded during use, the device will automatically activate the
overload protection.
3)
The system has overcharge and over discharge protection.
3.4.
Cleaning and maintenance
a)
Before each cleaning and when the device is not in use, pull out the mains plug of the power supply or
disconnect the solar panel from the inverter.
b)
Use only non-corrosive cleaners to clean the surface.
c)
After cleaning the device, all parts should be dried completely before using it again.
d)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
e)
Do not spray the device with a water jet or submerge it in water.
f)
Make sure that no water gets in through the openings in the housing.
g)
The device must be regularly inspected to check its technical efficiency and spot any damage.
h)
Use a soft cloth for cleaning.
i)
If the device has been exposed to low temperature, drops of water may solidify (inside or outside the
casing). In this case, wait until the device is completely dry before using it. Otherwise there is a risk of
electric shock.
j)
The device will turn off automatically when the battery voltage is too low. Remember to charge the
device within 15 days of discharging.
k)
Please make sure that the battery level is less than 30% before packing for transport.
l)
Please ensure that the device is fully charged before storing it for an extended period of time. Charge
the device every 3 months if not in use.
Publicidad
