Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
8
Connecting the water supply
lines
Use 1/2 in. I.P.S. faucet connections (2), or use
supply line coupling nuts (3) (not included) with
a 3/8 in. O.D. ball-nose riser (1).
Use wrenches to tighten the connections. Do
not overtighten.
1
Care and Cleaning
This faucet is designed for years of trouble-free performance. Keep it looking new by doing the following:
□
Clean periodically with a soft cloth.
□
Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish and void your warranty.
Troubleshooting
NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Problem
There are leaks
underneath the handle.
The aerator leaks or has
an inconsistent water
flow pattern.
The water will not shut off
completely.
2
3
Possible Cause
The retainer nut has come loose and the
O-ring on the cartridge is dirty or damaged.
The aerator is dirty or mis-fitted.
The rubber seat and spring is dirty or
broken.
9
Checking for leaks
Turn on the water supply to the faucet.
Use the aerator wrench to remove the aerator
(B) from the faucet (A).
Turn the handles on the faucet (A) and allow
the hot and cold water to run for at least 1
minute to flush out any debris and identify any
possible leaks.
When finished, turn the water off and replace
the aerator (B) with the aerator wrench.
□
□
□
□
□
□
7
Please contact 1-855-HD-GLACIER for further assistance.
A
B
Solution
Tighten the retainer nut.
Clear or replace the O-ring.
Remove the aerator and
check for debris in the aerator
screens.
Confirm that the rubber washer
is properly installed.
Remove the handle and car-
tridge to check the rubber seat
and spring.
Clean or replace.
HOMEDEPOT.com/GLACIERBAY
Publicidad
