Publicidad
Idiomas disponibles
Idiomas disponibles
USAGE INSTRUCTIONS
Before First Use
Wash the inside of the body with mild liquid detergent.
Rinse well the inside and dry the outside of the kettle. Place the base on a flat,
stable surface.
Follow the operating instructions and boil the water a few times and promptly
discard.
Operation of The Appliance
Unwind the plug from the cord winding channel at the bottom of the base.
Position the power base that came with your appliance on a flat stable
surface.
Open the lid and fill the kettle with the desired amount of water. Always fill the
kettle between the MIN and MAX marks.
Close the lid. Position the kettle on the power base in place.
Connect the plug into a power outlet. Press down the power button and the
indicator in the housing illuminates, it will start to boil the water then. The kettle
and the indicator will be switched off automatically once the water has boiled.
Lift the kettle from the power base and then pour the water.
The appliance must be cooled down for 30~45 seconds before boiling water
next time.
Do not overfill water over Max limit in the kettle, as boiling water will
overflow during heating.
In case there is any smell during operation of the appliance, switch it off
and contact the customer service.
MAINTENANCE
Care
Remove the plug from the power outlet and let the appliance completely cool
down before cleaning.
Clean your appliance periodically to help maintain its new appearance over
the years. Use only a soft and lint-free cloth to avoid scratching the finish. Do
not use water when cleaning. This could possibly cause an electric shock.
Periodically descaling is needed, the interval of descaling depends on the
hardness of water in your living area and the frequency of the appliance used.
Do not attempt to repair the kettle or power base for any problem, contact the
customer service only for help.
7
Troubleshooting
Problem
Cause
The safety protection has
been activated due to the
appliance being operated
without water.
The appliance does
not turn ON.
The plug is not properly
inserted in the socket.
The cord is defective.
The base of the kettle has
The appliance
excessive scale built-up.
turns OFF before
Too little water has been
boiling.
added.
Difficulty in pouring
Scale built-up near the
water
spout.
Solution
Let the appliance cool down
before attempting to boil water
again.
Check the plug and insert it
properly.
Contact the customer service.
Frequent descaling is needed.
Add more water until it reaches
at least the minimum level.
Frequent descaling is needed.
8
Publicidad
