Operating the unit
1. Open the battery door and insert 2*1.5V AAA batteries properly.
2. Pull the trigger to turn on the unit.
3. Aim at the target surface and pull the trigger, then temperature will be shown on the LCD. This
unit is equipped with a laser, which is only used for aiming.
Locating a Hot Spot
To find a hot spot, aim the thermometer outside of interest, then scan across with an up and down
motion until you locate the hot spot.
Maintenance
•
Lens Cleaning: Blow off loose particles using clean compressed air. Gently brush remaining
debris away with a moist cotton swab. The swab may be moistened with water.
•
Case cleaning: Clean the case with a damp sponge/ cloth and mild soap.
•
Note: Do not use solvent to clean plastic lens.
•
Note: Do not submerge the unit in water.
Specification
Temperature range: -50 - 500°C (58 - 932°F)
Accuracy:
-50 - 500°C (58 - 932°F): ±1.5°C (±2.7°F) or ± 1.5%
-50 - 0°C (58°F - 32°F): ±3.0°C (±5.0°F) whichever is greater
Resolution: 0.1°C or 0.1°F
Repeatability: 1% of reading or 1°C
Response time: 500 mSec, 95% response
Emissivity: 0.95 preset
Distance to spot size: 12:1
Operating temperature: 0 - 40°C (32 - 104°F)
Operating Humidity: 10 ~ 90% RH, non-condensing, up to 30°C (86°F)
Storage Temperature: -20°C – 60°C (-4°F – 140°F)
Power: 2x 1.5V battery AAA (excluded)
Typical battery life: 12 Hours (laser off)
Laser max. ouput: 1 mW
Laser wave length: 630 - 650 nm
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment.
Disposal
Dispose of this product and battery at the end of its working life in compliance with the
EU Directive on Waste Electrical and Electronic Equipment. When the product is no longer
required, it must be disposed of in an environmentally protective way. Contact your local
solid waste authority for recycling information or give the product for disposal to BGS
technic or to the dealer where you purchased the product.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed