Publicidad
Idiomas disponibles
Idiomas disponibles
MENU: Press this button to start the time setting. Then press the TIME SETTINGS (time setting) button to increase the time
value by 5 minutes. Each time the REDUCE TEMPERATURE / TIME button (temperature/time reduction) is pressed, 5
minutes will be subtracted. Maximum time that can be set: 90 minutes.
TEMPERATURE CONTROL (temperature setting): Press this button to start setting the temperature. The display will show a
flashing "075". Then press the TIME SETTINGS button (time setting) to increase the temperature value by 5°C (each time this
button is pressed it will increase by 5°C). Press the REDUCE TEMPERATURE / TIME button (temperature/time reduction) to
decrease the set temperature value by 5°C. Maximum temperature value that can be set: 250°C. Once the desired
temperature has been set, the display flashes 5 times and the unit enters normal operation mode with the set parameters.
TIME SETTINGS (time setting): button for setting time and temperature values.
REDUCE TEMPERATURE / TIME (temperature/time reduction): button for reducing the set temperature and time values.
RESET KEY: button to clear the entered settings and turn off the device.
3.2.
Preparing for use
APPLIANCE LOCATION
The temperature of environment must not be higher than 40°C and the relative humidity should be less than 85%. Ensure
good ventilation in the room in which the device is being used. There should be at least 10 cm distance between each side of
the device and the wall or other objects. The device should always be used when positioned on an even, stable, clean,
fireproof and dry surface, and be out of the reach of children and persons with limited mental and sensory functions.
Position the device such that you always have access to the power plug. The power cord connected to the appliance must be
properly grounded and correspond to the technical details on the product label.
3.3.
Device use
Connect the device to the power supply. Set the operating parameters in accordance with the description of the control
panel.
After finishing work, turn off the device and disconnect it from the power supply.
3.4.
Cleaning and maintenance
a)
Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or replacement of
accessories, or if the device is not being used.
b)
Use only non-corrosive cleaners to clean the surface.
c)
After cleaning the device, all parts should be dried completely before using it again.
d)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
e)
Do not spray the device with a water jet or submerge it in water.
f)
Do not allow water to get inside the device through vents in the housing of the device.
g)
Clean the vents with a brush and compressed air.
h)
The device must be regularly inspected to check its technical efficiency and spot any damage.
i)
Use a soft cloth for cleaning.
j)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they may damage the
surface material of the appliance.
k)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or other chemical
substances because it may damage the device.
DISPOSING OF USED DEVICES:
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device recycling and
collection point. Check the symbol on the product, instruction manual and packaging. The plastics used to construct the
device can be recycled in accordance with their markings. By choosing to recycle you are making a significant contribution to
the protection of our environment.
Contact local authorities for information on your local recycling facility.
Publicidad
