Publicidad
Idiomas disponibles
Idiomas disponibles
The round
hale at the
entrance
NOTE: Your fingers must never enter the in-feed chute.
NOTE: Never use the tool if the hopper is not fitted.
NOTE: Do not over reach.
NOTE: Feed from the right side of the feed hole
How do I collect the shredded material?
Shut-off the power unit before attaching or removing the bag.
You can use either the collection bag supplied (if supplied) or place the shredder on
a tarpaulin sheet to catch the shredded material.
When using the collection bag, you need to fit the collection bag hooks onto the
sides of the discharge chute.
Warning: The ventilation slots on the machine body must never be covered by the
collection bag or shredded material.
How do I replace the blades?
1. Ensure that the shredder is switched off and disconnected from the mains
supply.
2. Remove the top feed assembly by unscrewing the reamer knob securing it to the
body of the machine.
3. The blades have two cutting edges. When the blades become worn they can be
reversed to use the second cutting edge.
4. It is recommended that work gloves be used when replacing the blades.
5. Lock the blade disc using hex spanner. Unscrew the two inner hexagonal
headed screws and note the position of the cutting angle of the blade.
6. Remove the blade and rotate it through 180 degrees and fit the blade to the
blade disc ensuring that the ground cutting edge is facing downwards.
Repeat this for the other blade.
Fig. 7
11
EN
Plunger
Material
Fig. 8
Publicidad
