Publicidad
Idiomas disponibles
Idiomas disponibles
16
en
DELETE MEMORY
Press the VM/VF button, and the "Memory address" will flash in the upper right corner
of the screen. Then use one of the following methods to remove unwanted stations:
METHOD 1: DELETE A SINGLE MEMORY MANUALLY
Turn the TUNING KNOB to select the
memory you want to delete, press and
hold the [DELETE] button until the
word "dEL" and "memory address"
flash; then press the [DELETE] button
to erase the unwanted station from
memory.
METHOD 2: SEMI-AUTO DELETE MEMORY
Press and hold the VM button until
"PRESET " flashes to automatically
search for stored stations, press the
[DELETE] button at any time to directly
delete unwanted memory; The radio will
continue searching until you press any
other button to stop this function.
METHOD 3: MANUALLY DELETE ALL MEMORY WITHIN THE BAND
Press and hold the [DELETE] button
until the word "ALL" flashes in the
upper right corner of the screen, then
press the [DELETE] button to erase all
memory within the selected band.
SLEEP FUNCTION
1.
Press and hold the POWER
button until "SLEEP" and "ON"
or 1~120" show on the display.
2.
Rotate the TUNING KNOB
immediately to select sleep
timer from 1 to 120 minutes or
select permanently "ON", then
wait until the radio automatically
turns on to confirm the setting.
CLOCK SETTING
1.
Press & hold the TIME button
until hours flashing, then rotate
the TUNING KNOB to adjust
the hour.
2.
Press the TIME button, then
rotate the TUNING KNOB
to adjust the minutes while
minutes are flashing.
The auto scan function will
store all the available stations
in the ETM memory.
3.
Press the TIME button to confirm the setting.
Notes:
•
If the TIME button has not been pressed again within 3 seconds, the unit will
automatically confirm the setting.
•
You can also directly key-in the number to set the clock after pressing and holding
the TIME button, this allows the user to set the time by pressing the numeric keys,
then you will hear a prolonged beep sound suggesting that the time has been set.
For example, to set the clock to 6:35, just enter 0 6 3 5.
ALARM
It is recommended to set the alarm by buzzer if you are not familiar with the local radio
frequency and air time.
SETTING THE ALARM BY BUZZER
1.
Press and hold the ALARM button
until the hour flashes in the upper
right corner, then turn the TUNING
KNOB to set the hours.
Press and hold the ALARM button,
2.
then rotate the TUNING KNOB to
adjust the minutes while they're
flashing.
3.
Press the ALARM button again to
confirm the setting.
Note:
•
If the ALARM button has not been pressed again within 3 seconds, the unit will
automatically confirm the alarm setting.
17
Publicidad
