Palram Harmony 6x14 Manual De Instrucciones página 9

IMPORTANT
Please read
these instructions carefully before you start to assemble this product
.
Please carry
out the
steps in the order set
out
in these instructions.
Keep
these instructions
in
a
safe
place for future reference.
Safety Advice
For safety purposes we
strongly recommend the product to
be assembled by at least
two
people.
Some parts may have sharp edges. Please be
careful when handling components. Always wear
gloves, eye
protection,
and long sleeves
when assembling or performing any maintenance on your
product.
Do
not attempt to
assemble the product
in
windy or wet conditions.
Do
not attempt to
assemble the
product if you
are tired, have taken drugs,
medications or alcohol, or if you
are
prone to dizzy spells.
Dispose
of
all
plastic
bags safely
-
keep them away from children's
reach.
Keep
children away from the assembly
area.
When using
a
stepladder or power tools, make sure
that you
are
following
the manufacturer's safety advice.
Keep roof and gutters clear
of
snow,
dirt
& leaves.
Heavy snow load on the roof can make it unsafe to stand below or nearby.
Do
not
lean
against or push the product during construction.
Hot items such
as
recently
used grills,
blowtorches
etc. must not be
stored inside the product.
Heavy or sharp articles should not
be
leaned against the wall panels.
Make Sure there are no
hidden pipes or cables
in
the ground before inserting the
pegs
(not supplied)
Do
not touch overhead power
cables
with the aluminum profiles.
If
color was scratched during assembly it can be fixed.
Note:
Th
is
product must
be
anchored on to
a
leveled surface and solid foundation to ensure its
stability.
Make sure
that
screws and anchors are
compatible with foundation type.
Make sure
that there
are no
obstructions between the assembly area and the final position.
Cleaning Instructions
In
order to clean the product,
use
a
mild detergent solution
and rinse
with
cold clean water.
Do
not
use
acetone, abrasive cleaners, or other special detergents to clean the
panels.
Clean
the product once assembly
is
complete.
Before Assembly
Choose
your
site
carefully before beginning
assembly.
The
ground
surface must be perfectly flat and leveled.
Choose
a
sunny area, away
from overhanging
trees.
Do
not position your product
in an area
exposed to excessive winds.
The
product must
be
positioned and fixed onto
a
flat leveled
surface.
We
strongly recommend to secure
this product directly onto
a
solid
foundation.
Use
the pre-drilled holes
in
the steel base.
Complete
site
preparation before unpacking parts and beginning
assembly.
Sort the parts and check against the content parts
list.
Parts
should
be laid
out
close at hand. Keep all small parts (screws etc.) in
a
bowl
so
they
do not get lost.
Please
consult your local authorities if any permits
are
required prior to constructing the
product.