Descargar Imprimir esta página

Tesmed Trio 6.5 Manual De Instrucciones página 122

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Fully comply with the following daily maintenance requirements are necessary, to make sure
your product operate intact and guarantee the product Long-term performance and safety.
8.1 Cleaning and caring for the device
8.1.1 Clean the device with a soft, slightly damp cloth. In case of heavier dirt build-up, you may
also add a mild detergent.
8.1.2 Do not subject the New Stimu to moisture or dampness. Do not hold the New Stimu under
running water, do not submerge it in water or other liquids.
8.1.3 The New Stimu is sensitive to heat and may not be exposed to direct sunlight. Do not place
Trio 6.5
the New Stimu on hot surfaces.
Trio 6.5
8.1.4 Carefully clean the surface of the adhesive electrode with a damp cloth. Make sure the
device is turn off!
8.1.5 For reasons of hygiene, each user should use his/ her own set of electrode.
8.1.6 Do not use any chemical cleaners or abrasive agents for cleaning.
8.1.7 Ensure that no water penetrates into the machine. If this should ever happen, only use the
device again once it is completely dry.
8.2 Cleaning and caring for the electrodes and electrode cables
8.2.1 Clean the electrode cords by wiping them with damp cloth. Coating them lightly with
talcum powder will reduce tangles and prolong the life.
8.2.2 After used the electrode pads, please keep them in the sealed bag properly. Improperly
storage will lead to the gel moisture loss and viscosity reduced, breeding ground for bacte-
ria.
8.3 Maintenance
8.3.1 The manufacturer didn't authorize to any maintenance agencies abroad. If your device has
any problem, please contact the distributor. The manufacturer will not be held responsible
for the results of maintenance or repairs by unauthorized persons.
8.3.2 The user must not attempt any repairs to the device or any of its accessories. Please contact
the retailer for repair.
8.3.3 Opening of the equipment by unauthorized agencies is not allowed and will terminate any
claim to warranty.
Each product in manufacturing has been through the systematic validation. The performance is
stable and did not need to undertake the performance parameters of calibration and validation
If your product can't reach the expected performance and the basic function have change in
normal use, please contact the retailer.
Tesmed copyright - it is absolutely forbidden the partial or total reproduction of any present content
8. CLEANING AND MAINTENANCE
Trio 6.5
122
Trio 6.5
22

Publicidad

loading

Productos relacionados para Tesmed Trio 6.5