Twin-Star International Tresanti ODP10555-48D908 Instrucciones De Montaje página 5

Lock Button:
Press this button to lock the touch-screen. This will prevent accidentally engaging the controls after the desired
height has been set. Press the button again to unlock the touch-screen.
Press and hold this button, then plug in the power cord until the screen light to reset to the default setting.
To change between INCHS and CM press and hold this Lock button for 5 seconds.
Silent-Mode:
All operations are performed under this default mode.
Display:
The display will indicate the height of the desk (inches). Afer five seconds without input, the digital readout
will automatically fade away.
When the desk has reached the lowest setting, the display will indicate "bot".
When the desk has reached the highest setting, the display will indicate "top".
Touch and hold one of the memory buttons (H1-H4) for 3 seconds when the desk is at the desired height in
order to save it as a memory preset. The table will automatically return to the set height when the
corresponding memory button is touched.
Touch and hold the
The table is at the lowest height setting when "bot" is displayed.
Touch and hold the
The table is at the highest height setting when "top" is displayed.
USB Ports:
There are 3 USB ports suitable for charging devices with 2.4A charging power requirement (or lower).
The USB ports will pause charging temporarily when the height of the table is being adjusted and the motor is
in use.
A591
Control Panel
button to lower the table and release when it arrives at the desired height.
button to raise the table and release when it arrives at the desired height.
Operation
5
USB Ports 2.4 A
Lock Button
MP#MG