Macally HRMOUNTPROTRAY Guia Del Usuario página 2

GB USER GUIDE
Thank you for
HRMOUNTPROTRAY dual position car seat headrest
tablet mount with table tray. The Macally
HRMOUNTPROTRAY
comfortably eat while watching movies on their tablet
from the back seat of the car. The headrest mount can
be easily and securely attached to the car's front seat
headrest posts with a width of 2"/5,1 cm to 7¼"/18,4 cm.
The cradle fits any tablet and mobile device with a width
of 4.5"/11,5 cm to 10"/25,5 cm. The strong aluminum
frame can be extended so that the holder can be placed
in the center (between the two front seats) so that all
passengers can enjoy the same movie, at the same
time. The cradle is fully adjustable and can rotate
between portrait and landscape view. The large 12.4"
(31.5 cm) wide fold down table has a 3"/7.6 cm wide cup
holder (2.5"/6.3 cm deep) and a raised lip to securely
keep drinks and food in place while on the road.
About this guide
Before you start using the HRMOUNTPROTRAY, be
sure to read this guide in its entirety.
Package contents
• HRMOUNTPROTRAY
• User guide
Hardware basics
Extension lock lever
Extension arm
Cup holder
Table tray
Tray load max:
5 lbs / 2.2 kg
purchasing the Macally
allows passengers
Cradle holder
release lever
Cradle holder
Cradle angle adjustment
ball-head screw cap
Head post clamps
Clamp
knobs
Tray angle
adjustment knob
Tray lock latch
Spring loaded
grip extension
to
Top arm-grip
release buttons
Slide-Out bottom arm grips for tablet
How to use the HRMOUNTPROTRAY
The HRMOUNTPROTRAY is shipped so that it can
be mounted on the back "passenger side" seat
(extension arm pulling out from the left side).
Please refer to the "Driver side seat mounting"
section of this user guide for steps on how to flip the
table tray.
1. Pull the tray downward, loosen the tray angle
adjustment knob and bring the headrest bar
upward. You can make adjustments to the tray
angle once it's mounted by loosening and
tightening the tray angle adjustment knob as
needed.
2. Loosen the head post clamps, place the clamps
onto the headrest posts and then firmly tighten
them into place by turning the clamp knobs
1