Publicidad
Idiomas disponibles
Idiomas disponibles
English
NOTE: USE TWO PEOPLE TO ASSEMBLE THIS TABLE.
1. STAND the rear CMS
®
(Cable Management System)
frame (B) upright with the two cut outs facing up.
2. ALIGN the bottom shelf frame (D) with the bolt holes
in the bottom sides of the CMS
ATTACH using 35mm medium size bolts (2). DO NOT
TIGHTEN FULLY.
3. ALIGN the middle shelf frame (C) with the bolt holes
in the middle rear CMS frame (B), and, ATTACH using
100mm long bolts (3). DO NOT TIGHTEN FULLY.
4. SLIDE the inserts on the leg edges (E and F) into the
ends of the bottom shelf frame (D), and the middle
shelf frame (C) as shown in Fig. 2. Attach each with
16mm smaller screws (7).
NOTE: The legs are in the proper position when the
angled inserts are at the bottom of the leg and facing
forward as indicated in Fig.2.
5. ALIGN the top shelf frame (AA) with the bolt holes in
the top rear CMS
®
frame (B) making sure the larger
holes in the rear bar are facing up and ATTACH with
middle size 35mm bolts (2).
6. NOW GO BACK AND FULLY TIGHTEN ALL BOLTS.
NOTE: MOVE the table to the location it will occupy when
fully assembled and in use BEFORE placing the glass
shelves.
7. APPLY two of the larger pads (5) to the front of the
middle shelf frame and APPLY the smaller pads (6) to
the front and rear of the bottom frame where shown in
Fig. 2. PLACE the bottom shelf (I) onto the bottom
frame (D) with the curved glass edge facing forward.
ADJUST the preinstalled adjustable glass pads in the
front of the TOP shelf frame to ensure the glass shelf
is level. Do this before placing items on the glass.
NOTE: The bottom shelf is not as wide as the others.
8. INSERT suction cups (4) into the middle shelf frame
(C) holes and push into place. CENTER AND PLACE
the middle glass shelf (H), the one without the silver
discs, onto the middle shelf frame and GENTLY push
downward to create a seal. The curved glass edge
should face forward.
NOTE: The suction cups limit the movement of the shelf
and still allow easy shelf removal. To release the seal,
gently pull down on the suction cup edge.
9. PLACE caps (1) over the open top area of the top shelf
frame (AA). PLACE the top shelf (G), with the silver
discs, onto the top shelf frame. INSERT the discs into
the rear top frame holes. The curved glass edge
should face the front. SECURE the discs from below
with the 35mm (2) bolts. DO NOT OVERTIGHTEN.
®
frame (B) and
Fig. 1
Fig. 2
Fig. 3
Publicidad
