Descargar Imprimir esta página

Craftsman 917.28634 Manual Del Operador página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

The operation
of any tractor can
result in foreign
objects thrown
into the
eyes, which can result in severe eye damage,
Always
wear safety glasses
or eye shietds
while operating
your tractor
or performing
any adjustments
or repairs.
We recommend
standard
safety glasses
or a wide vision safety
mask worn over spectacIes.
HOW TO USE YOUR TRACTOR
TO SET PARKING
BRAKE
Your tractor is equipped
with an operator
presence
sensing
switch.
When
engine
is running,
any attempt
by the operator
to leave the seat without
first setting
the
parking
brake wili shut off the engine.
I_
Depress
brake pedal (B) all the way
down and hold.
2.
Pull parking
brake lever (C) up and
hold, release
pressure
from brake
pedal (B), then release
parking
brake
lever.
Pedal should
remain
in brake
position.
Make sure parking
brake will
hold tractor securer
STOPPING
MOWER
BLADES
-
• To stop mower blades,
move at-
tachment
clutch lever in to disengaged
position
( r_
),
(I-_)
Attachment
(r_)
Disengaged
Clutch
Position
Engage Position
GROUND
DRIVE
-
• To stop ground
drive, depress
brake
pedal all the way down.
ENGINE
-
• Move throttle
control (D) between
half
and full speed
(fast) position.
NOTE:
Failure to move throttle
control
between
half and full speed
(fast) posi-
tion, before stopping,
may cause engine to
"backfire"°
• Turn ignition
key (F) to "STOP"
position
and remove
key
Always
remove
key
when leaving
tractor to prevent
unau-
thorized
use.
IMPORTANT:
Leaving the ignition switch
in any position other than "STOP" will
cause the battery to discharge
and go
dead.
NOTE:
Under certain conditions
when
tractor
is standing
idle with the engine run-
ning, hot engine
exhaust
gases may cause
"browning"
of grass°
To eliminate
this pos-
sibility, always
stop engine when stopping
tractor
on grass areas.
_CAUTION:
Always
stop tractor
com-
pletely, as described
above,
before leaving
the operator's
position.
TO MOVE
FORWARD
AND
BACKWARD
The direction
and speed of movement
is controlled
by the forward
and reverse
drive pedals°
1_ Start tractor
and release
parking
brake.
2. Slowly depress
forward
(K) or reverse
(L) drive pedal to begin movement.
Ground
speed
increases
the further
down the pedal is depressed
11

Publicidad

loading