Publicidad
Idiomas disponibles
Idiomas disponibles
Electric Lunch Box Use instructions
Product description Fig.A
1. Steam valve
2. Cover lock
3. Handle
4. Spoon storage
5. Body
6. Power light
7. Container wit h 2 compartments
8. Internal compartment with cover
9. Spoon
Instruction for use
Before using, wash and dry the plates. Then put the food into the plates.
Insert the plate into the lunch box, then, fasten down the lunch box lid to the lunch box.
Plug in the device
Power indicator lights up and the device starts heating the food
Notice: the heating time depends on food quantity and its initial temperature. Generally 25-40 minutes
are enough. At low temperature, i.E. Refrigerated food, heating time can increase.
Unplug the device before enjoying the meal.
Warning: in order not to damage the device, press the air valve with your fingertip to open when
operating. The container is not hermetic.
Cleaning and maintenance
The plug must be unplugged after use.
Should be cleaned immediately after use for avoiding the odor.
Do not use the petrol, cleanser powder, hard brush, stainless steel wire ball to clean the electric lunch box.
It is allowed to put a little warm water to clean inside or use the soft warm cloth to wipe it.
If the lunch box is in a long period no use, please clean it and pack in the gift box, and put general
Dry filling so as not to damp and impact the use.
Any problems in the lunch box, please send it to the company's repair department or contact the repair de-
partment of our company. Personal demolition is prohibited.
Trouble shooting
Problem
No heating, indicator do not light
up
No heating, indicator light up
The temperature is too low after
finish
Technical specifications
Voltage: 240V~50/60Hz
Power: 40W
Capacity 1000 ml + 450 ml
For any improvement reasons, Beper reserves the right to modify or improve the product without any notice.
Cause
1. Power do not plug in
2. Power cord is damage
Heating element is damaged
1. The heating time is too short
2. Ambient temperature, rice, dish
and soup temperature is too low
9
Solution
Check the plug, power cord, plug
in power cable
Send to the certain repair de-
partment
Extended the heating time
EN
Publicidad
