GE ZKW36V Instrucciones De Instalación página 3

36" STANDARD INSTALLATION
CHANGE POWER CORD
Longer power cords are required for standard install kit
installation. Power cords are included in the Standard
Install Kit.
Remove existing short power cord with string
assembly:
Remove 1/4" hex screws attaching rear access cover.
1. Unplug 3-pin power cord connector inside the
machine compartment (press on sides to release
locking tabs).
2. Remove power cord green ground 1/4" hex screw.
3. Remove strain relief 1/4" hex screw.
Step 2
Green Ground
Screw
Step 3
Strain Relief
Screw
CASE TRIM INSTALLATION
Install the trim kit
side rails to the
exposed right and
left case walls
using the provided
#8 Phillips head
screws - 15 screws
per side.
31-1000725 Rev. 1
Installation Instructions
Step 1
3-Pin
Power Cord
Connector
3-Pin
Power Cord
Connector
Rear
Access
Cover
Install new longer power cord:
1. Plug in the 3-pin connector (make sure locking tabs
are engaged).
2. Install the power cord green ground screw.
3. Install the power cord strain relief.
WARNING
To avoid the risk of electric shock, make sure to re-install
the ground screw after changing the power cord.
AVERTISSEMENT
Pour éviter le risque d'électrocution, assurez-vous de
réinstaller la vis de mise à la terre après avoir changé le
cordon d'alimentation.
ADVERTENCIA
Eléctrica.
A fin de evitar riesgos de descarga eléctrica,
asegúrese de volver a instalar el tornillo de conexión a tierra
luego de cambiar el cable de corriente.
Replace rear access cover. Make sure the power
cord and ground wire are properly routed through the
access cover cut-out.
Step 3
Fit the top trim and side trim rails together by sliding
the exposed edges of the corner trim into the right and
left trim kit side rails. Align and drive the two number
10-24 Phillips head screws into the screw bosses in
the side rails to ensure the top trim is snugly fit to the
side rails.
Secure the top trim to the case by using the provided
#8 Phillips head screws (2 screws).
3
Electrical Shock Hazard.
Risque d'électrocution.
Riesgo de Descarga
Step 2
Ground
Wire
Power
Cord