Publicidad
Idiomas disponibles
Idiomas disponibles
72" STANDARD INSTALLATION
STANDARD INSTALLATION SPACE (Cont.)
Dimensions in parentheses are in centimeters.
*83-1/2" min.
*84-1/2" max.
(212.1-214.6)
ELECTRIC
*Trim will overlap additional 3/4"
**Trim will overlap additional 3/4" on each side
INSTALL WATER LINE JUMPER/TEE
Connect to potable water supply
WARNING
only.
Raccordez l'appareil à une
AVERTISSEMENT
alimentation d'eau potable seulement.
Realice la conexión a un suministro
ADVERTENCIA
de agua potable únicamente
Connect the jumper water line from the Standard
Install Kit to the house cold water line. Tighten the
compression nut hand tight, then tighten one additional
turn with a wrench. Overtightening can cause leaks!
31-1000725 Rev. 1
Installation Instructions
**71-1/2" (181.6)
WATER
ELECTRIC
WATER
Minimum Clearance Dimensions with Trims Installed
• 3/4" Landing needed for cabinetry door/drawer edge
adjacent with hinge opposite of cutout.
• 1-1/2" landing needed for cabinetry door/drawer edge
with hinge adjacent to cutout
Trim
Trim Overlap
0.75 min
Hinge Opposite
Cutout.
(Only used on 72" Standard Installation.)
Connect the other end of the jumper water line to the
water fitting tee supplied in the 72" Standard Install Kit.
Tighten the compression nut hand tight, then tighten
one additional turn with a wrench. Overtightening can
cause leaks!
Water Fitting Tee
5
1.5 min
Hinge Adjacent
to Cutout.
Water Line Jumper
Publicidad
