Publicidad
Idiomas disponibles
Idiomas disponibles
1. Twist, then pull off spark plug boot.
2.
Remove spark plug from cylinder
and discard.
LINE REPLACEMENT
Pre-wound spools offerthe most con-
3.
Replace with Champion RCJ-6Y
spark plug and tighten securely
with a 3/4 inch socket wrench.
4.
Reinstall the spark plug boot.
venient method for replacing line and
ensuring optimum
performance.
• Replacement
spools are color-
coded to ensure use of the correct
spool with your unit. Be sure to use
the same color spool as the existing
spool.
NOTE:
Always clear dirt and debris
from cutting head components when
performing any type of maintenance.
• Hold spool and unscrew cap by turn-
ing in the direction shown on top of
the cap.
• Remove
line guide ring and spool.
Line guide ring
Cap
"_
0-
0oo,
Use a pre-wound spool or refill spool
withline.If using a pre-wound spool,
remove tape strip from line and spool.
REFILLING
THE SPOOL WITH LINE
WARNING:
Use only 0.080
inch (2 mm) diameter
round
line.
Other sizes and shapes of line wilt not
advance properly and will result in im-
proper cutting head function or can
cause serious injury. Do not use other
materials
such as wire, string, rope,
etc. Wire can break off during cutting
and become a dangerous
missile that
can cause serious injury.
1. Cut a length of 25 feet of 0.080
inch (2 mm) diameter
round
Craftsman
brand line.
_
Feed line in
_'_"_\_,
direCtion
"_L¥-_ 1 shown on
= oo,
Spool
2.
Insert one end of line into center
cavity of empty spool.
Ensure line
will feed into spool in the direction
shown on the spool (counterclock-
wise).
3.
Continue feedingline
into spooJ,
leaving 4 - 6 inches (10 - 15 cm)
unwound
from center of spool.
INSTALLING
SPOOL WITH LINE
1.
Install replacement spool.
2.
Thread line through line guide ring.
Line through guide ring
"__
Slot
Replacement Spool
3.
Rest guide ring on spool and place
line through
slot. Allow line to ex-
tend 4 - 6 inches (10 - 15 cm)
from center of spool.
4.
Ensure line remains in slot while
screwlngcap
on to the shaft.
Only tighten cap hand tight!
CARBURETOR
ADJUSTMENT
_ WARNING:
Keep others away
when making idle speed adjustments.
The trimmer head or any optional
at-
tachment
will be spinning
during most
of this procedure.
Wear your protec-
tive equipment and observe
all safety
precautions.
After making adjust-
ments
the trimmer
head or any op-
tional attachment
must not move/sp n
at idle speed.
15
Publicidad
