Craftsman 580.752601 Manual De Instrucciones página 6

Yourpressure w asher requires someassembly a ndis
readyforuseonlyafterit hasbeenproperly serviced
withthe recommended oilandfuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
REMOVE PRESSURE WASHER
FROM CARTON
Slice two corners opposite guide handle end of
carton from top to bottom so the panel can be
folded down flat.
Remove fillers, accesories and parts bag shipped
with your pressure washer.
Roll the pressure washer out the open end of the
carton.
Check carton for additional loose parts.
Attach Handle
1 Place handle assembly onto handle supports
connected to main unit Make sure holes in handle
align with holes on handle supports
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts through holes from outside of
unit and attach a plastic knob from inside of unit.
Tighten by hand.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
The main unit
Handle 3
Spray gun
High pressure hose
Nozzle extension with Hi/Lo adjustable nozzle
Engine oil
Parts bag (which includes items listed below)
Owner's manual
Registration card
Handle attachment hardware
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on page 5 If any parts are missing or 4
damaged, call the pressure washer helpline at
1-800-222-3136
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1 Attach handle
2 Add oil to engine crankcase
3 Add fuel to fuel tank.
4. Connect pressure hose to spray gun and pump.
5. Connect water supply to pump.
Insert one "L" hooks through hole just under
billboard on left side of handle (viewing from rear
of unit). Hold hook in place with pliers and attach
Iocknut with a 7/16" wrench.
Insert other "L" hook through hole just above
billboard on right side of handle (viewing from rear
of unit). Hold hook in place with pliers and attach
Iocknut with a 7/16" wrench.
Add
Engine
Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, SG, SH, SJ or higher rated SAE 30
weight. DO NOT use special additives
6