Publicidad
Idiomas disponibles
Idiomas disponibles
WAC
8-24
USER
MAN
FINAL
3/2/05
12:13
PH
Page
11£
iNSTALLATiON iNSTRUCTiONS
2. Preparation
to Remove the
Air Conditioner
Slide-Out
Chassis
A. Remove total of (4) Philips screws securing
the chassis to the cabinet. There are (2) screws
on each side. The set of screws closest to the
front of the unit secure the front panel to the
cabinet. The set of screw closest to the rear of
the unit secure the cabinet to the chassis.
See (Fig. 1).
B. Remove the front panel assembly from the
cabinet by gently pulling it.
C. Grasp the pull handle at the front of the
slide-out
chassis and carefully slide the
air conditioner
out of the cabinet, See (Fig. 2).
Please
seek assistance
for this procedure.
Note: Screws
must be reinstafled
upon
completion
of the window
installation
to
secure
slide-out
chassis,
Right side
Philips
screws
Fig. 1
Coil
Pull Handle
Fig. 2
3. Assembly
of the upper
& lower
channels
to
the cabinet
A. " L" Shaped Top Channel:
Stick the double
adhering
seal to the " L" shaped top channel,
and
then Install the "L" shaped top channel to the
cabinet as shown in (Fig. 3) using (5) 1/4" screws.
B. "n" Shaped Bottom Channel installed as
shown in (Fig. 3)using (4) 1/4" screws.
NOTE: For 15K to 24K
models,
the bottom
channel
has been factory-
installed,
and their shapes
may
differ
from the others, but their functions
are similar.
4. Assembly
of the side shutters
(curtains)
to the cabinet.
Slide the shutters
into the top and bottom
channels as shown in (Fig. 4). The shutters
are
identified
(on each frame) as "left" & "right".
Attach
the shutters to the cabinet using (4) 114" screws
on each side.
Double
w
Adhering seal
1/4" Screw
For 8K to 12K models
For 15K to 24K models
(Factory-installed)
Fig. 3
Shutter Frame
Fig. 4
Publicidad
